There is some kernel configuration that's critical to this using the default raspbian should be fine, but if you've rolled your own you need the following options under Device Drivers -> Network Device Support -> USB Network Adapters: If it's not there and modprobe cdc_ether fails, keep reading. On a raspbian pi it will almost certainly be usb0. Link/ether b8:27:eb:2c:bd:8c brd ff:ff:ff:ff:ff:ffģ: usb0: mtu 1500 qdisc noop state DOWN mode DEFAULT qlen 1000 After you plug in the tablet and enable tethering, you should be able to see the interface with ip link: > ip linkġ: lo: mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT
0 Comments
Leave a Reply. |